The table shows the pin configuration of the Arduino UNO–based robotic arm. The red (VCC) wires of all servos are connected ...

It’s fair to say that building electronic gadgets is easier now than it ever has been in the past. With low-cost modular components, there’s often just a couple dozen lines of code and a few jumper ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

ClearCore CLCR-4-13 is an industrial IO and motion controller that can be programmed using the Arduino IDE. It handles up to four axes of step-and-direction motion control (500kHz max step rate), and ...

It’s increasingly common for designers to pair stepper motors with motion-control SoCs. In fact, more design engineers than ever are setting up SoCs themselves for motion applications. These chips ...